Desktop Mounting
The device can be placed on a desktop when its four anti-slide bumpers (supplied) are attached to the underside of the device.
To ensure proper cooling and prevent over-heating of internal components:
|
●
|
Do not place any equipment directly on top of the device. |
|
●
|
The side panels of the chassis, where the air vents are located, must remain unobstructed to ensure adequate airflow through the chassis. Make sure that clearance from the ventilation openings is at least 13 cm. |
|
➢
|
To attach the anti-slide rubber bumpers to the device: |
|
1.
|
Flip the device over so that its underside faces up. |
|
2.
|
Locate the four anti-slide grooves on the underside - one in each corner. |
|
3.
|
Peel off the adhesive, anti-slide rubber feet and stick one in each anti-slide groove. |
Rubber Foot Attached to Underside of Device
|
4.
|
Flip the device over again so that it rests on the rubber feet and place it in the required position on a desktop. |